Diag Jumpers On Btt Skr. V3 X and Y DIAG PIN ,about bigtreetech/BIGTREETECHSKRminiE3 Git (Define DIAG_JUMPERS_REMOVED to suppress this warning.)" [-Wcpp] 706 | #warning "Motherboard DIAG jumpers must be removed when SENSORLESS_HOMING is disabled The jumper goes on the pair of pins marked X-DIAG or Y-DIAG etc
Bigtreetech BTT SKR 3 EZ V1.0 Control Board from 3dgadgets.my
If you want to use sensorless homing, a jumper needs adding under each driver you want to use it for as shown below If you are using Flymaker TMC2209 drivers, you need to enable the DIAG pin on the driver
Bigtreetech BTT SKR 3 EZ V1.0 Control Board
4 jumpers in the bag, and a 5th on the board, but its not 100% clear to me what to do with them. Therefore, it should be noted when using TMC2209 on the board with DIAG function :(such as SKR E3 DIP V1.0, BTT002 V1.0, SKR Pro V1.1, etc.)If you use the TMC2209 but needn't use the Shenzhen BIGTREE technology co., LTD. 4 jumpers in the bag, and a 5th on the board, but its not 100% clear to me what to do with them.
BigTreeTech SKR Mini E3 V3.0 NotEnoughTech. The jumper goes on the pair of pins marked X-DIAG or Y-DIAG etc Fly 2209 Diag Pin off Fly 2209 Diag Pin on Config.g Changes
Bigtreetech BTT SKR 3 EZ V1.0 Control Board. But as a coder, I'd still like to know from someone where to put it exactly (for readability and easier finding) I am using klipper and need to know what are the pin name for the diag pin for X and Y ( and other if there is ? Can you help me out ?